WInk Instructions
It takes just 10 minutes to 1 hour to transform your space into something fun, cool and exciting with WInk. Please follow the instructions to ensure ease of transforming your space.
Step 1: Planning
It is always good to plan your design to determine the look you want. You can make a sketch or use tape to temporary stick your patterns on the surface you are working on.
Although WInk’s decals come in pre-spaced form, you can cut out the individual elements to create the design that you want. This is where you showcase your creativity.
Step 2: Preparation
Ensure that your surface is dry, smooth and clean. In most cases, a wipe with damp cloth and waiting for it to dry should work for a clean surface. If needed, Isopropyl alcohol works well to remove any dirt or residue that might prevent WInk from sticking to the surface. Do not expose WInk under direct sunlight. |
|
Step 3: Removing backing
 |
|
Rub firmly over the entire graphic with the WInk Tool Card attached. Slowly peel the thick paper backing at 180 (as steep as possible) degree angle away from the graphic. |
|
 |
|
The graphic should stick on the transfer (clear) tape. If the graphic is not adhering to the transfer tape, simply lay the backing paper back on the tape and rub with the WInk Tool Card. |
The graphic should stick on the transfer (clear) tape. If the graphic is not adhering to the transfer tape, simply lay the backing paper back on the tape and rub with the WInk Tool Card.
Step 4: Affixing
 |
|
Once the backing is removed, take care not to let the adhesive side of the graphic stick onto itself as it is extremely sticky. Place one side of the transfer tape onto the space you want to stick (eg. Wall, window etc) and move your hand slowly and firmly over the sticker towards the opposite side of the tape. |
|
 |
|
Now that you have the transfer tape and graphic in place, rub the transfer tape and graphic with the WInk Tool Card provided to remove any bubbles. |
|
 |
|
Slowly remove the transfer tape from the wall at 45 degree angle and make sure the graphic sticks to the wall. Show pic IF not, lay back the tape and rub with WInk Tool Card again before removing the transfer tape. |
|
|
|
|
Step 5: Viola and enjoy!
Congratulations! You are now a proud owner of WInk products and the admiration of many for that cool wall.
You may use WInk Tool Card as a bookmark or luggage tag. We always welcome your feedback on how you creatively use WInk Tool Card.
We also encourage you to take a picture of your new Wink space and upload onto www.winkplay.com gallery to share with the community.
Removal
To remove the decals, simply use a tweezers to pick at one corner of the graphic. Warming up the decal a little with a hairdryer will also help ease the removal process.
Once you have one small corner, SLOWLY peel at 135 degree away from the surface. Take care to do it slow.
You are now ready for a new WInk design.
Feel free to call us at +65-67603907 or email feedback@winkplay.com for any advise.
Problems?
Bubbles:
If there are bubbles trapped in the decal, use the Wink Tool Card to push the bubbles out. If that is not possible, try to push as many bubbles as possible into 1 location. Then use a pin or needle to poke a tiny hole in the bubble and push the air out. The hole should be hardly visible.
Wrinkles:
Slowly peel the decal at the edge nearest to the wrinkle. When you reach the wrinkle, straighten it and pull firmly down to re-stick the decal.
|
